Insert 3 planks into one arm and then slide the other arm on the planks. Assemble the bench back by inserting the planking in the arms (D), use 2 large planks (A) on the outside slots and 1 small plank (B) in the middle slot.To convert bench into table, pull the back of the bench forward until the armrest sits on the leg assembly.Space 2 braces at about 1/3, 1/3, 1/3 of the width of the bench, as shown). The smaller end of the support will slide in the small 2 X 4 pre-drilled plank. The seat of the bench will sit on the long part of the support. When assembling braces, it is necessary to turn each one so it will lie flat, then push end onto plank. Insert the 2 support braces (E) onto the pre-drilled small planking (C) under the seat of bench.This is a snug fit which might require a screwdriver or hammer to tap in securely. After these are aligned, insert the plastic hinge pin through the hole on the hinge. Make sure the bottom of the arm touches the top of the bench bottom. Attach bench back to bench bottom by aligning the slot at the bottom front of the arm with the knuckle on the top of the leg.Make sure that each plank is completely inserted into each arm slot. Assemble the bench back by inserting the planking in the arms (D), use 3 large planks (A).Attach nylon locking nuts and tighten (but DO NOT OVER-TIGHTEN). For a secure fit, this may require a small hammer to lightly tap bolts into place through the holes. Insert bolts from the hardware pack through the holes in the legs and lower plank. Match up pre-drilled holes in the lower brace of both legs to the pre-drilled holes in the lower plank (C). Attach other leg (F) onto the planking, making sure all four planks are completely inserted into all leg slots.Next insert small planking with pre-drilled holes (C) into middle slot of lower pre-drilled brace part of one of the legs (F).(DO NOT use small plank with pre-drilled holes). Use two large planks (A) in the outside slots and one small plank (B) into the middle slot. Start assembly of bench bottom by inserting planking into the slots of one leg (F).2 Hinge pins & 4 – 2 1/4 inch bolts with locking nylon nuts.(C) 1 Small Plank with pre-drilled holes (2 X 4).TOOLS NEEDED: Phillips head screwdriver and a 3/8″ wrench, or socket wrench, or adjustable wrench. THE PRODUCT (1 BENCH) HAS BEEN TESTED TO 1,000 LBS STATIC LOAD. DO NOT CALL RETAILER or return product to retailer. NOTE: Please call the toll free Customer Service number 1-80 with any assembly or parts problems. Two benches required for full picnic table. Convert A Bench Full Instructions (Download)
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |